Classifying the Types of Seals

Depending on the direction that squeeze is applied to the O-rings cross section on a seal, it will be categorized as an AXIAL or RADIAL seal.

Static Axial Seals

A static axial seal will act in a similar manner to a gasket that is squeezed on both the top and the bottom of an O-ring’s cross section. A static axial seal is used in face (flange) type applications. When it is used as a face seal and there is internal or external pressure, the O-ring should be positioned against the low-pressure side of the groove to cut down on O-ring movement and accompanying wear within the groove.

These seals are easier to design than static radial seals since there is no extrusion gap and fewer design steps. This enables you to control the tolerances more easily.

Static Radial Seals

Typically used in cap and plug type applications, static radial seals are squeezed between the inner and outer surface of the O-ring.

Static Crush Seals

The O-ring is confined and pressure deformed (crushed) within a triangular gland which is made by machining a 45-degree angle on the male cover. In crush seal applications, the seal is squeezed at an angle to the O-ring’s axis.

Static Seals with Dovetail Glands

Sometimes O-rings are used in static or slow moving dynamic situations where a specially machined “dovetail” gland needs to be used. Controlling tolerances in the glands can be difficult because of the angles involved. The glands are meant to securely hold the O-ring in place while the machine is in operation or during maintenance and disassembly.

The O-ring squeeze is mostly axial in direction and valve operations puts force on the top and bottom seal surfaces. So that there is no tearing or nicking, the use of an O-ring lubrication is recommending while the O-ring is being installed into the dovetail gland. It is difficult to create the groove and tight tolerances are required so this type of seal application should only be used when necessary.

Reciprocating Seals

Reciprocating seals are used when there is a moving piston and rod. This is the most common dynamic application for O-rings.

Rotary Seals

Rotary seals are used for rotating shafts with the turning shaft protruding from the ID of the O-ring.

Oscillating Seals

The shaft of an oscillating O-ring application moves in an arc within the gland and is in contact with the ID of the seal. The shaft can twist so self-lubricated O-rings with a hardness of 80 to 90 durometers are most often used. If there is graphite containing compounds caution is necessary as they can pit stainless steel alloys.

Real Seal manufactures and distributes seal products and mechanical component goods. Established in 1970 as a distributor of O-rings, we are now a full-service supplier of sealing and mechanical components for many different industries.

One of the most technically advanced organizations in the industry, Real Seal maintains a fully equipped laboratory with a full-time chemist and technical staff. We are able to assist you with your design challenges and formulate materials that meet your specific needs for any types of seals. We can provide solutions to your problems and create an increased value for your company.