Bettering Your Gasket Sealing

During auto repairs, gas and exhaust leaks are costly and frustrating problems that arise quite frequently. To fix any leaks that happen in your engine or pipes, gasket seals are used to effectively tighten and close the area that is experiencing leakage. However, if the gasket seals are not placed precisely or installed tightly enough, the problem will continue, making more repairs necessary. To avoid this frustration and extra cost of a second repair, Real Seal has a comprehensive guide to show how you can better your gasket seals for a high-quality repair that will last for miles.

Finding the Correct Sealant

Often the most obvious problem happens when customers and repair men do not read the specific seal labels or do not follow every step of the instructions. To avoid this minor but costly frustration, make sure you are shopping for the sealant that will fix your exact leak problem. Read the full set of instructions and applicable uses before purchasing or using on your leaks. Following through with this simple step is an easy process that will save you time and money in the future.

Use Caution when Cleaning

When you’re preparing the two surfaces that are about to bond, be mindful to avoid causing any new or worse scratches, dents or punctures. Abrasive metal scrapers are not the only product that can get your gaskets cleaned and they could end up causing more damage and more leaking potential if you press too hard or scrape over existing punctures. Any form of scraping product used to clean is a risk on the existing structure, so be gentle throughout your entire cleaning process to avoid new damages.

Read up on the Specifics

Whether you’re binding engine leaks or pipe leaks, every car, brand and piece of equipment is made differently. Reading up on current models and specifics can only help you throughout the binding process. Metal types and parts models change seasonally and a bond you’ve used for other leaks may not be the right choice for the new repair you are trying to fix. It is also important to know which gasket seal you should be utilizing in every situation. If you are unsure of the kind of seal you need for your metal and part type, or you want to know what seals have been shown to work the best, check out our gasket seals guide and read through the options. Failure to use the correct type of gasket seal can mean that your leak fix will not hold, and your repair will only last for a short period of time. Avoid future stress, frustration and extra repair costs by doing a little homework into the parts and gasket seals before you begin work.

Prep the Parts

Another common problem with gasket seals that don’t last is a failure to effectively prep the work area. There are several pre-emptive steps available to ensure that the seal to hold up over a long period of time. Effectively cleaning both bonding surfaces is a necessary and time saving process that will allow for a seal to grab on to the organic metal and not a coating of grease or dirt build up. If the surfaces are not cleaned properly, the gasket seals are unable to bind effectively and will malfunction quickly. When installing gasket seals, you can also use lubricant products such as Vaseline to help the gasket stay in the correct place during the repair and to also aid in allowing the installation to slide in easier when you are ready to bind.

If you’re beginning a gasket seal repair and need the help of quality professionals and products, Real Seal is here to help you find what you’re looking for and answer any of your sealant questions.

This entry was posted in Uncategorized by admin. Bookmark the permalink.